* Subject to conditions
|
Dedicated clip-on transmitter for E-TTL/E-TTL II wireless flash system Features E-TTL Compatible Built-in AF-Assist Beam Sets and Controls Flash Rations High-Speed FP Flash E-TTL Wireless Autoflash Control Type550EX-dedicated, clip-on Speedlite transmitter with direct contacts.
Compatible Cameras: Type A EOS cameras (E- TTL, autoflash); Type B EOS cameras (Manual flash) Sync SpeedHigh-Speed Sync (FP flash): Enabled with high-speed sync mode Flash Exposure Confirmation1. Before flash fires during FE lock Adequate flash exposure indicated by the flash exposure level icon lit in the viewfinder. Insufficient flash exposure indicated by the flash exposure level icon blinking in the viewfinder. After flash fires ST-E2's flash confirmation lamp lights in green for 3 sec. AF Assist Beam. Compatible with EOS-3's 45-point Area AF and 28mm and longer lens focal lengthsEffective Range: Approx. 0.6 to 10m/2.0 to 16.5 ft along the periphery (in total darkness). Wireless Functions Transmission SystemInfrared pulse Transmission RangeIndoors: Approx. 12-15 m/39.4 - 49.2 ft; Outdoors: Approx. 8-10 m/ 26.2-32.8 ft Flash Ratio ControlFor A:B ratio: 1:8 to 8:1, in half- step increments or 13 steps Flash CoverageTransmission Coverage: +/-40 degrees horizontal and +/-30 degrees vertical Slave Operation ConfirmationWith test transmission button.*Slave A fires followed by slave B at 1/64 output. Slave Unit SE Mode CancellationCancels when the test transmission button or FE lock botton is pressed to turn on the slave unit. General Power Source2CR5 lithium battery x 1Battery Life: Approx. 1,500 transmissions (At room temperature and with a new set of batteries) SE ModeWhile the power switch is set to I or HOLD, the transmission turns off automatically after about 90 sec. of non-use. Dimensions:62 (W) x 51 (H) x 80 (D)mm/2.4 (W) x 3.1 (D) in Weight: 100g/3.5 oz (exluding battery)
|
When you have spent a lot of money on some new equipment, you want to be sure that you'll still be using it in a year or more's time. DD Electronics Extended Product Protection plan offers low cost care for your peace of mind, whatever your purchase.
Extended Product Protection is available on new equipment and provides you with full protection for your product for 3 years and 5 years and on some lenses, it's 7 years . The offer is available on:
Your product is protected from the moment you buy, wherever you use it:
For more information please go to www.mackcam.com
This information is provided to help you decide whether to purchase a Extended Protection Plan on the equipment you have purchased from us.
You do not have to buy a Extended Protection Plan at the same time you purchase your equipment. We recommend you purchase extended warranty at time of purchase to keep all your particulars on the one invoice, however you can purchase any time within 30 days from the date you purchase your equipment.
We will always repair your equipment, subject to the full terms and conditions of your plan, unless:
If we do not repair the equipment, we will replace it with equipment of the same or similar make and specification. If your product was not new when you purchased it, we will replace it with used equipment of the same or similar specification or refund the original purchase price of the equipment if the same or similar equipment is not available.
If we cannot reasonably arrange a replacement we will pay refund the purchase price paid. When we have replaced your equipment, your plan will end and there will be no refund of the fee you have paid.
Repairs or replacement of Equipment or claims under the protection will not be provided or reimbursed if they are still protected by any supplier's or repairer's guarantee or arise from:
a) The Equipment being recalled by us or the supplier.
b) Any modification of the Equipment.
c) Your failure to follow the Equipment's operating instructions.
d) Theft, attempted theft, malicious damage or damage caused by fire or explosion.
e) Floods, lightning, storms, frost or other bad weather conditions.
f) Any problem with the supply of electricity.
g) No fault being found by our repairer with your Equipment.
h) Routine maintenance, cleaning and servicing.
i) Your inability to use your equipment or from damage caused as a result of the equipment breaking down.
j) Cosmetic damage such as damage to paintwork or dents or scratches to the Equipment.
k) Replacement of any item or accessory that is intended to be replaceable. These include fuses, batteries, light bulbs, attachments, cables and plugs.
l) Rust, corrosion or water damage unless you are protected for damage caused accidentally.
m) Problems with: Software, (application or operating system), damage caused by viruses, accessories which you have not told us about in writing.
n) Loss of images and failure, loss or damage to storage media.
o) Any losses you may incur as a result of inability to use your equipment.
International Service Center
For Singapore/Australia /USA customers you can contact DD Electronics directly to assist with your Mack Extended Protection Plan for customers in other countries who need to have your equipment serviced under your Mack Camera Extended Protection Plan, please follow these instructions for obtaining service.
DD Electronics Pte Ltd or Mack Camera will respond via email with a control number to obtain an estimate for the repair.
To avoid delay in having repairs approved, please forward the detailed estimate to our warranty department by e-mail atsales@d-d-electronics.com.sg international@mackcam.com or fax at (973) 467-0776.
The estimate should include a detailed description of what will be repaired, including part numbers and the reason for the repair. YOU MUST HAVE MACK CAMERA APPROVAL ON ESTIMATES PRIOR TO ANY WORK BEING DONE.